Lacp default port priority. Site will be available soon. LACP uses the port priority to decide which ports should be put in standby mode when there is a hardware limitation that prevents all compatible ports from aggregating. To revert to its default setting, use the no form of this command. LACP system priority—You must configure an LACP system priority on each device running LACP. For more information on features that use this command, refer to the Link Aggregation Guide for your switch model. Dec 5, 2006 · Examples Configuring the LACP System ID and Port Priority Examples Removing a Channel Group from a Port Examples Displaying Gigabit EtherChannel Information Configuration Examples for LACP (802. We can also change the interface priority using the interface configuration ‘lacp port-priority <number>’ command. This information determines the LAG of a port. For example, if the maximum number of port channel member interfaces is set to 1, then G0/0 will be the active interface because it has a lower interface number. Reverting the LACP port ID to the default: switch (config-if)# no lacp port-priority. zjue olmd xyezr oypxmge qnvix faey mphrm wkpt qkcyjwo bva